Gator Rubber, Paint
and Tar Remover +

For concrete pavers, wet cast and natural stones

APPLICATION INSTRUCTIONS

PLEASE NOTE
  • This product dissolves sealants.
  • Do not let product dry up on paver surface.
  • Wear goggles and rubber gloves.
  • Use at above 60°F (16°C) in dry conditions.
STEP 1
Apply product to stain.
STEP 2
Let it soak for 5 minutes.
STEP 3
Apply product again.
STEP 4
Immediately scrub with hard bristle brush.
STEP 5

Repeat steps 3 and 4 until stain dissolves.

STEP 6
Rinse thoroughly with water.
IMPORTANT

GATOR RUBBER, PAINT AND TAR REMOVER + will also dissolve any existing sealer. In order to maintain a uniform color, clean the entire paver surface with Gator Efflorescence cleaner.

ALLIANCE DESIGNER PRODUCTS INC. cannot guarantee results as it has no control over surface preparation and product application. If this product is proven to be defective, on the condition that it was applied pursuant to the required method of application and surface preparation, the sole obligation of ALLIANCE DESIGNER PRODUCTS INC. is to refund the purchase price. Proof of purchase is required for any claim. ALLIANCE DESIGNER PRODUCTS INC. shall not be liable for any other damages whatsoever, direct or consequential. To the extent permitted by law, ALLIANCE DESIGNER PRODUCTS INC. excludes any implied warranty of quality, merchantability or fitness for purpose.

*Please store container at above 32°F / 0°C.

POLYMERIC SAND
FOR DUMMIES

Tue. 1/23
1PM EST

Live Broadcast
Gator Studio